• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

Fiat 500 Key Fob Replacement

If your 500 keyfob ceases working, try a different one to see if it is able to be detected by your car. If it does, it could be a problem related to the battery, or water damage to the fob that was originally used.

Replace the battery first. The "+" side should be facing down.

Dead Battery

The battery is often the reason behind the fob's inability to function. It's not difficult to fix, and most fobs warn you when the battery is low. There are instructions on YouTube for nearly every key fob on your vehicle or in your owner's manual. You can also take it to a local locksmith or to the dealer that sold it to you to replace it.

Sometimes a fob will stop working due to a problem on the internal circuit board. It's not often however it can occur. The internal chip can be damaged in the event you drop the fob onto something hard. It can be a problem if you have an aftermarket fob and the key doesn't work. In this case it is imperative to go to a dealer or locksmith to have the key reprogrammed so that it works with your 500.

One 2012 FIAT FIAT 500 flip key remote – Looks like Ilco with lock, unlock, and trunk buttons – new replacement keyless entry (will need to cut & program by locksmith).

Chips damaged

A key fob from Fiat 500 is an wireless device that sends the signal needed for the car to start after you press the button. It's equipped with a microchip, which contains information about the code that will allow it to communicate with the car. If the chip is damaged, it can't transmit the correct code and the car will not start. A locksmith can fix the damage. United Locksmith is capable of offering this service to classic models as well, as for newer models, so don't be afraid to call them.

A locksmith can program a new key fob. It's less expensive to do this instead of going to the dealer, and it performs the same. You will need to provide certain details to the locksmith, for example, the year your vehicle was built and the model.

If you're not sure of the best solution to this problem you can try rubbing the chip with an US dollar bill. The copper on the bill is abrasive enough remove dirt and oxidation, but it will not cause any harm to the microchip. The chip might not be repairable if it is physically damaged. This could happen if you drop it or run it over by your vehicle.

Water Damage

Water damage is likely to occur on your fob, whether you dropped it in the pool by accident or put them in pockets while swimming, or splashed water on them during a rainy afternoon. Even if there's only a small amount of water on the key, it could cause serious issues with its electronics.

You can usually fix this issue by removing the fob and cleaning it using a paper towel. When the fob is dry and clean, you can replace the battery and it should begin working again.

You can also take it to an auto shop or locksmith to get it professionally cleaned and programmed. These experts can make use of special equipment to make sure that the fob's key works with your car's computers.

If your Fiat 500's main fob isn't working, it can be stressful and frustrating. It can be expensive and cumbersome to take your key fob to the dealer. A locksmith can replace your key fob without needing to visit an auto dealer. They are a better option than a dealer since they can handle all aspects of the replacement key for fiat 500 of your car's key fob without the requirement for a dealership visit.

Pairing Issues